What is the function of 4 pin Molex P4 12V?.What is the purpose of the 4 pin Molex connector?.What are the different color cables found in Molex connector?.The male part of the fan is just so you don’t lose a connector by using the fan and can connect to any other molex female connector in your setup to supply power. The female part of the Fan-Molex-Connector to the male connector of the PSU. The molex connectors are to connect the fans directly to the PSU. The SATA power connector includes a 3.3 volt rail as well as the traditional 5 volt and 12 volt rails. A Molex to SATA connector should be fine for most HDDs and DVD Drives but it may not be sufficient for more modern SSDs and BluRay drives. In the same way Should I use Molex to SATA? Safe, yes. Compatible connectors are available from many manufacturers, not just Molex and AMP. The large one on the right is used for disk, CD-ROM and DVD drives, while the small connector is used for floppy drives and other devices.Īlso, What type of device would you connect a Molex cable to?Ĭertain Molex connectors are used for providing power to the motherboard, fans, floppy disk drive, CD/DVD drive, video card, some older hard drive models, and more. These « Molex » connectors bring DC power to the drives inside a PC case. In addition, What does a Molex plug into? Then you use molex connectors to connect the fans to your power supply rather than the motherboard. In 2016, FCI Asia Pte was acquired by Amphenol.Molex connectors are necessary when you don’t have any 3 pin headers left on your board to connect fans. In 1998, Berg Electronics was acquired by FCI (Framatome Connectors International) for $1.85 billion. The male PCB connector on the 3½-inch floppy drive is a polarized right-angle male header, which is a TE Connectivity / AMP 171826-4, the straight model is AMP 171825-4. The plastic connector housing is TE Connectivity / AMP 171822-4 with female metal contact pins are choice of TE Connectivity / AMP 170204-* or 170262-*, where * is 1 or 2 or 4. The power cable from the ATX power supply consists of 20 AWG wire to a 4-pin female connector. The power connector on the 3½-inch floppy drive, informally known as "the Berg connector", is 2.50 mm pitch (distance from center to center of pins). the two-pin Berg connectors used as jumpers for motherboard configuration.įloppy drive power connector Floppy Drive Power Connector.the two-pin Berg connectors used to connect the front panel lights, turbo switch, and reset button to the motherboard.the four-pin polarized Berg connectors used to connect 3½-inch floppy disk drive units to the power supply unit, usually referred to as simply a "floppy power connector", but often also referred to as LP4.Some of the more familiar ones used in IBM PC compatibles are: Louis, Missouri, now part of Amphenol.īerg connectors have a 2.54 mm (0.100 in) pitch, pins are 0.64 mm (0.025 in) square, and usually come as single or double row connectors. Berg connectors are manufactured by Berg Electronics Corporation of St. Berg connector for power is shown on the left data cable on right.īerg connector is a brand of electrical connector used in computer hardware.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |